Webkey - How to Create and Configure Factor Sequence - Oloid

Introduction

Prerequisites

Ensure Auth Policy is created.

Steps to Create Factor Sequence

Log in to the Tenant Admin Portal.
Select Security > Click Factor Sequencing. The Factor Sequence for Adaptive MFA page is displayed.
Click Create Factor Sequence. The Create Factor Sequence pop-up box is displayed.
Do the following:
1. Enter Factor Sequence Name.
2. Select Webkey from the Application Type dropdown.
3. Click Create. The Factor Sequence Details page is displayed.
Do the following:

Configure Online Rule. Configure Offline Rule.

Configure Online Rule.

Select Online Rule tab > Click +Add Rule.
Do the following:
1. Select the IF credential from dropdown.
2. Select Auth Policy from dropdown. Auth Policy must be created for Factor sequence. Refer:
3. Select THEN rule from dropdown.
  1. Select Allow (OR)
  2. Select Second factor > Select checkbox of the required credential as second factor.
4. Click Save. The Online Rule is configured. To create a new rule click +Add Rule again and repeat the aforementioned steps.

Configure Offline Rule.

Select Offline Rule tab > Click +Add Rule.
Do the following:
1. Select the IF credential from dropdown.
2. Select THEN rule from dropdown.
  1. Select Allow (OR)
  2. Select Second factor > Select checkbox of the required credential as second factor.
3. Click Save. The Offline Rule is configured. To create a new rule click +Add Rule again and repeat the aforementioned steps.

Add Policy Sub-Type

Under AND Apply Policy section click Edit.
Select Policy Sub-type from dropdown.
1. Select Condition If User has used from dropdown,
2. Select PIN credential from credential dropdown.
3. Set Auth session time limit.
4. Click Save. Multiple Policy Sub-type rules can be added for each rule.

⌘I